Opc server for ac 800M, Installation and Configuration

tải về 0.83 Mb.

Chế độ xem pdf

trang	10/36
Chuyển đổi dữ liệu	17.09.2023
Kích	0.83 Mb.
	#55155

1 ... 6 7 8 9 10 11 12 13 ... 36

3BSE035983-510 - en AC 800M 5.1 OPC Server

Prerequisites and Requirements
Configuration

Clock Synchronization
OPC Server for AC 800M contains a function for clock synchronization. If enabled,
the OPC server will time synchronize all connected controllers at a certain interval
(also, see
Clock Synchronization
on page 28).
Prerequisites and Requirements
OPC Server for AC 800M requires Windows 7 or Windows Server 2008 operating
system, and ethernet for controller communication.
This type of clock synchronization should only be used if there is no clock master
synchronization throughout the controller network. The clock master could be an
AC 800M controller, but also another type of controller, for example an AC 400
controller.

Section 1 Introduction
Intended User
3BSE035983-510
19

Intended User
The three beginning sections in this manual covers configuration issues and should
be studied by both 800xA and CCB Users. However, the remaining sections with
start from
Section 4, Data Access
, only concern CCB Users and can therefore be
ignored by 800xA Users.

Intended User
Section 1 Introduction
20
3BSE035983-510

3BSE035983-510
21

Section 2 Start-up and Configuration
This section will give you start-up information and basic information regarding how
to configure the OPC Server for AC 800M.
Configuration
After running the Setup Wizard it is time to start the OPC Server Configuration
Panel for specification of controllers to be connected.
To open the OPC Server Configuration Panel:

tải về 0.83 Mb.

Chia sẻ với bạn bè của bạn:

1 ... 6 7 8 9 10 11 12 13 ... 36