BSE035983-510 7 Section 5 - Alarm and Event

Table of Contents
8
3BSE035983-510
 

3BSE035983-510
9
 
About This Book
General
This manual covers configuration issues (completely) for Compact Control Builder 
(CCB) Users and (partly) for 800xA Users. Therefore, if you run OPC Servers in an 
800xA system, only the first part of this manual concerns you, which means exactly 
up to and including Section 3. Hence, if you wish to run OPC Servers with Compact 
Control Builder, you are advised to studying the complete manual.
Since the behavior of the OPC Server is different depending on a CCB or 800xA 
situation, a preset of separate installation instructions can be found in the manual 
Getting Started
1
(CCB), or System Installation
2
(800xA) respectively. 
Section 1, Introduction
, introduces OPC Server for AC 800M and what should be 
considered before installing and configuring the product.
Section 2, Start-up and Configuration
gives a description on how to set up the 
system and start the OPC Server Configuration Panel for the first time and 
configure the settings from there.
Section 3, OPC Server Operation
deals with subjects applicable for both parts of 
OPC Server for AC 800M. The different parts of OPC Server is described in Section 
4 and Section 5.
Section 4, Data Access
 describes the OPC Data Access Server.
Section 5, Alarm and Event
describes the OPC Alarm and Event Server.
Appendix A, Running the OPC Server and OPC Client on Different Computers
This product meets the requirements specified in EMC Directive 89/336/EEC and in 
Low Voltage Directive 72/23/EEC.
1.
Getting Started, Introduction and Installation, (3BSE041584*) provides installation instructions for Compact 
Control Builder Users.
2.
System Installation, (3BSE034678*) provides installation instructions for 800xA Users.

Document Conventions
About This Book
10
3BSE035983-510

tải về 0.83 Mb.

Chia sẻ với bạn bè của bạn: