|
NI6001 code vf-s11, BÁO CÁO MÔN ĐƯỜNG LỐI, bao cao mon hoc trang bịDocument Outline - NI USB-6001/6002/6003 User Guide
- Table 1. Differences Between the NI USB-6001, NI USB-6002, and NI USB-6003
- Figure 1. NI USB-6001/6002/6003 Top and Side Views
- Safety Guidelines
- Electromagnetic Compatibility Guidelines
- Unpacking
- Setting Up the NI USB-6001/6002/6003
- Installing the Software
- Preparing the Hardware
- Figure 2. Hardware Setup for NI USB-6001/6002/6003
- Verifying the Installation
- Using the NI USB-6001/6002/6003 in an Application
- Example Programs
- NI-DAQ Assistant
- Table 2. NI-DAQ Assistant Tutorial Locations
- ANSI C without NI Application Software
- .NET Languages without NI Application Software
- Features
- Block Diagram
- Figure 3. NI USB-6001/6002/6003 Block Diagram
- LED Indicator
- Table 3. LED State/Device Status
- Screw Terminal Connector Plugs
- Cables and Accessories
- Pinout and Signal Descriptions
- Figure 4. NI USB-6001/6002/6003 Pinout
- Table 5. Signal Descriptions
- Analog Input
- Figure 5. NI USB-6001/6002/6003 Analog Input Circuitry
- Analog Input Modes
- Taking Differential Measurements
- Figure 6. Connecting a Differential Voltage Signal
- Figure 7. Example of a Differential ±10 V Measurement
- Taking Referenced Single-Ended Measurements
- Figure 8. Connecting a Referenced Single-Ended Voltage Signal
- Signal Sources and Recommended Input Configuration
- Table 6. NI USB-6001/6002/6003 Analog Input Configuration
- Floating Signal Sources
- Ground-Referenced Signal Sources
- Input Range
- Figure 9. Analog Input Range
- Figure 10. Exceeding ±10 V on AI Returns Clipped Results
- Multichannel Scanning Considerations
- AI Start Trigger
- Analog Output
- Figure 11. Analog Output Circuitry
- Connecting Analog Output Signals
- Figure 12. Connecting the Analog Ouput Loads
- Power-On State
- AO Range
- Minimizing Glitches on the Output Signal
- Analog Output Data Generation Methods
- AO Start Trigger
- Digital I/O
- Figure 13. Example of Connecting a Load
- Power-On States
- Source/Sink Information
- Figure 14. Example of Connecting an External User-Provided Resistor
- I/O Protection
- PFI 0 and PFI 1
- +5 V Power Source
- Figure 15. +5 V Power Source Circuitry
- Connecting the Load
- Figure 16. Connecting +5 V Power Source Load
- Enable +5 V Power Source
- Related Documentation
- Examples
- NI USB-6001/6002/6003
- NI-DAQmx
- LabVIEW
- LabWindows/CVI
- Measurement Studio
- ANSI C without NI Application Software
- .NET Languages without NI Application Software
- Training Courses
- Technical Support on the Web
- Worldwide Support and Services
Chia sẻ với bạn bè của bạn: |
|
|