Parker Hannifin Corporation
Hydraulic Valve Division
Elyria, Ohio, USA
Dimensions
Series BD15
No. 4 SAE
Inch eqivalents for millimeter dimensions are shown in (**)
BD15 Installation Data
Mounting Screws, Soc. Hd. Cap
5/16-18 Th x 1.00 long
Torque
110 to 150 in. lbs.
O-ring Grooves
0.560 Dia. x 0.052 deep
O-ring Size
2-013 (70 Durometer)
Elec. Connector Mates with -
MS3106-14S-2S
Notes: 1. Servovalve mating surface to be flat within
0.002 inch TIR, and smooth to within 63 rms.
2. Servovalve mounting screws are to be torqued to
110-150 in.-lbs., above run down torque.
3. For proper orifice selection and decal part number,
refer to Table 1.
8.4 (0.33)
Mounting Holes
4 Places
Positive current to the Pin “B”
yields flow from the C1 port.
Other options change polarity
or use pin "D" instead of "B".
See ordering information page
for details.
Standard Wiring
Flow Control Servovalves
Bulletin HY14-1450-M1/US
Bul 1450-M1pgs.p65, dd
3
Parker Hannifin Corporation
Hydraulic Valve Division
Elyria, Ohio, USA
Dimensions
Series BD15, CSA Version BD15J*L
1/2" NPT
11.2
(0.44)
139.7
(5.50)
120.9
(4.76)
50.3
(1.98)
12.7
(0.50)
81.3
(3.20)
9.9
(0.39)
87.1
(3.43)
106.4
(4.19)
C1
Minimum cable length 18"
Access for
Null Adjust
Pilot
Pressure
Test Port
Red Wire
(+)
(-)
Black Wire
+ Voltage to Red Wire
connects P C2 port
Gnd
CSA Wiring
Green Wire
BD15 Installation Data
Mounting Screws, Soc. Hd. Cap
5/16-18 Th x 1.00 long
Torque
110 to 150 in. lbs.
O-ring Grooves
0.560 Dia. x 0.052 deep
O-ring Size
2-013 (70 Durometer)
Elec. Connector Mates with -
MS3106-14S-2S
Notes: 1. Servovalve mating surface to be flat within 0.002 inch TIR, and smooth to within 63 rms.
2. Servovalve mounting screws are to be torqued to 110-150 in.-lbs., above run down torque.
3. For proper orifice selection and decal part number, refer to Table 1.
8.4 (0.33)
Mounting Holes
4 Places
Inch eqivalents for millimeter dimensions are shown in (**)
Bulletin HY14-1450-M1/US
Bul 1450-M1pgs.p65, dd
Flow Control Servovalves
4
Chia sẻ với bạn bè của bạn: |
