Rf and if digitization in Radio Receivers: Theory, Concepts, and Examples



tải về 0.99 Mb.
Chế độ xem pdf
trang4/37
Chuyển đổi dữ liệu27.02.2022
Kích0.99 Mb.
#50663
1   2   3   4   5   6   7   8   9   ...   37
baseband signal
Chương-3, tham-số-hiệu-năng, OFDM vs OFDMA
2  ANALOG-TO-DIGITAL CONVERTERS  

The ADC is a key component in any radio that uses direct digitization of the RF input signal or 

that uses digitization after an initial downconversion to an IF. The other key component is the 

digital signal processor (discussed in Section 3).  

2.1  Sampling Methods and Analog Filtering  

The sampling process is critical for radio receivers using digitization at the RF or IF. The content 

of the resulting sampled signal waveform is highly dependent on the relationship between the 

sampling rate employed and the minimum and maximum frequency components of the analog 

input signal. Some common sampling techniques that utilize a uniform spacing between the 

samples include sampling at twice the maximum frequency, oversampling, quadrature sampling, 

and bandpass sampling (also called downsampling or direct downconversion). Sampling 

techniques with nonuniform spacing between the samples do exist but they are not widely used 

and therefore are not considered in this report.  

When a continuous-time analog signal is sampled uniformly, the spectrum of the original signal 



F(f) is repeated at integer multiples of the sampling frequency (i.e., F(f) becomes periodic). This 

is an inherent effect of sampling and cannot be avoided. This phenomenon is shown graphically 

in Figure 1. Figure 1(a) shows the spectrum of the original analog signal F(f). Figure 1(b) shows 

the spectrum of the sampled signal F



s

(f) using a sampling rate of f

s

=2f

max

.  



tải về 0.99 Mb.

Chia sẻ với bạn bè của bạn:
1   2   3   4   5   6   7   8   9   ...   37




Cơ sở dữ liệu được bảo vệ bởi bản quyền ©hocday.com 2024
được sử dụng cho việc quản lý

    Quê hương